Keys Made for Door Locks Is it possible for a locksmith to make a key from a lock? That’s a great question, and one that most people don’t think about. That is, until they require the services of a locksmith and are unsure how to locate one. The simple answer to the question of whether a locksmith can make a key from a lock is, yes. The processes necessary in doing so, however, are slightly more sophisticated, but still doable if handled by a professional locksmith. They essentially entail comprehending why a locksmith would need to produce a key from a lock as well as comprehending the methods by which this can be accomplished.
This question frequently occurs when someone requires an extra key. Most of the time, a locksmith will not have to make a key from a lock when asked to make a duplicate key because the original key is still working and intact. However, unless you hire a locksmith to produce a key from a lock, it will be difficult to make a new key if the key is broken or excessively worn out.
Understanding what causes you to wonder, “Can a locksmith make a key from a lock?” is vital for several reasons. The key reason is that it will assist you in avoiding a similar situation in the future. Consider being locked out of your house because you didn’t have your key. Would you like to go through it all over again? I would assume no.
Step#1: Cut the Key Code Remove the Key to Code Cutting the key to code may be the simplest method for a locksmith to create a key from a lock. However, just because it’s simple doesn’t mean it’s a viable option for every lock type. A key code is a string of characters used to create a key for a certain lock. When creating keys, there are essentially two sorts of key codes that are used. These are the blind and biting codes. In this instance, the bitting code is the one that a locksmith will pay the most attention to. This is due to the fact that these are the codes that are used to create actual keys from key blanks.
Step #2: Impression the Lock Impressioning a lock is significantly more straightforward than cutting a key to code. In short, impressioning a lock enables a locksmith to create a key from a lock without disassembling the complete lock cylinder or relying on decoding the lock. Because of how efficient and convenient it can be, this is frequently the go-to procedure for most locksmiths. Although impressioning is a useful method for locksmiths, it is not simple to understand or apply. It takes a lot of practice and fine tuning, just like lock picking.
Step #3:Disassemble the Lock When you are unable to cut the key to code or are unsuccessful in your attempt to breach the lock, you should disassemble it. Locksmiths will typically disassemble the complete lock cylinder in order to reverse engineer the key bitting from the alignment and height of the pins within the lock cylinder.
Disassembling the lock is a far more difficult task for locksmiths to do than impressioning the key. However, as previously said, it is not always feasible to properly impression a key and have it work as intended, which is why some locksmiths frequently have to disassemble the lock. To ensure that none of the internal mechanisms within the lock cylinder are damaged or forced out of alignment, the lock must be disassembled in a non-destructive manner. Forensic locksmiths frequently employ non-destructive access procedures to examine locks. Locksmiths must remove a pin-tumbler lock from the door it is installed on in order to properly disassemble it.
Is it possible for a locksmith to make a key from a lock? They certainly can! I hope that the preceding post has shown you how to answer this issue while also addressing some of the limits that may be encountered in a situation like this. Please note that it is not advisable to attempt any of these solutions on your own in order to avoid causing any unnecessary damage to your lock. Instead, llow a locksmith at BOB Locksmith to assist you make a key from a lock and we will get the job done properly for you